[Skyeye-developer] [ SkyEye Release ] Skyeye v1.21 is released.

[andy wang]

Hi, Kang

It's very nice to see the blackfin active again.

After I compiled the skyeye on the cygwin and tested with R0504, it
stopped after outputting following message and cpu is going to 100%...

I've checked with common output and found the next output would be
network driver. If I want to debug with skyeye and would like to see
where it go to infinite loop, could you please give me some
suggestions and advice?

Regards,
Andy

$ ./skyeye.exe -e linux-bf533
arch: blackfin
uart_mod:0, desc_in:, desc_out:
begin init emulator()
exec file "linux-bf533"'s format is elf32-little.
load section .text: addr = 0x00001000  size = 0x000d8500.
load section .init: addr = 0x000d9500  size = 0x0000d0a0.
load section .text_l1: lma = 0x000e65a0 (vma = 0xffa00000)  size = 0x000000cc.
not load section .data_l1: addr = 0xff800000  size = 0x00000000 .
load section .data: addr = 0x000e666c  size = 0x0002c9e8.
not load section .bss: addr = 0x00113060  size = 0x0000d4c4 .
not load section .comment: addr = 0x00000000  size = 0x00003162 .
load section .romfs: addr = 0x00120524  size = 0x00800000.
start addr is set to 0x00001000 by exec file.
 ↑Linux version 2.6.12.1-BFIN-2005R4 (root at sevens) (gcc version 3.4.4
(Blackfin 05R4 20051205)) #1 Wed Jan 11 15:33:21 C
ST 2006
Blackfin support (C) 2004 Analog Devices, Inc.
ADSP-BF533 Rev. 0.0
Warning: Unsupported Chip Revision ADSP-BF533 Rev. 0.0 detected
uClinux/BF533
Blackfin uClinux support by blackfin.uclinux.org
Processor Speed: 110 MHz core clock and 22 Mhz System Clock
Board Memory: 128MB
Memory map:
  text = 0x001000-0x0d9500
  data = 0x0e666c-0x113054
  bss  = 0x113060-0x120524
  rootfs = 0x7700000-0x7f00000
  stack = 0x0e8000-0x0ea000
Instruction Cache Enabled
Data Cache Enabled (write-through)
Hardware Trace Enabled
Built 1 zonelists
Kernel command line:
Configuring Blackfin Priority Driven Interrupts
PID hash table entries: 256 (order: 8, 4096 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Physical pages: 3c00
Memory available: 59648k/130150k RAM, (49k init code, 865k kernel
code, 231k data, 69632k dma)
Blackfin Scratchpad data SRAM: 4 KB
Blackfin DATA_A SRAM: 16 KB
Blackfin DATA_B SRAM: 16 KB
Security Framework v1.0.0 initialized
Capability LSM initialized
Mount-cache hash table entries: 512