[Skyeye-developer] ifconfig and route problem on skyeye

[kang shuo]

Did you try to ping your host from SkyEye or ping SkyEye simulator from your
host?You can give us more detailful info about your issue.
Check the following thing:
1. enable netcard option in your skyeye.conf
2.when you launch your uclinux on SkyEye, check if a tuntap module is added
to your host by lsmod command.
3.config the correct ip address of both your host side and SkyEye simulator
side.

On 5/21/06, yanjun lu <sybaselu @yahoo.com.cn> wrote:
>
> Hi all
>     I have tried more than once to connect backend on skyeye, but I always
> to be failed every times, so I have no chioce but to seek more helps from
> developers fo skyeye.
> 1 My work environment's :Fedore core 3, VMware, Xp
> 2 ARM7 is my  target hareware .
> In short, my question is that how to configure network to connect backend
> on skyeye
> Best regard, I would give you a great appreciation and thanks in advance
>
>
> __________________________________________________
> 赶快注册雅虎超大容量免费邮箱?
> http://cn.mail.yahoo.com
>
> _______________________________________________
> Skyeye-developer mailing list
> Skyeye-developer at lists.gro.clinux.org
> http://lists.gro.clinux.org/cgi-bin/mailman/listinfo/skyeye-developer
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.gro.clinux.org/pipermail/skyeye-developer/attachments/20060522/98e7bd37/attachment.htm