[Skyeye-developer] ifconfig

[kang shuo]

Did you compileyour network driver in your uClinux kernel or enable netcard
support in your skyeye.conf.
There is a good example in uClinux4skyeye package that can be downloaded
from gro.clinux.org.

On 5/16/06, cry <zyqmail at tom.com> wrote:
>
> hi all,
>
> After running LINUX on skyeye, I checked network( I have installed vnet,
> and successfully test it with testvnet1-testvnet7)
> and got:
> /> ifconfig -a
> lo        Link encap:Local Loopback
>           LOOPBACK  MTU:16436  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>
> where is the nic?
>
> /> ifconfig eth0
> eth0: error fetching interface information: Device not found
> pid 16: failed 256
>
> What can I do to get a nic?
>
> Thanks
>
>
>
>
>
>
>                     致
> 礼！
>
>             cry
>             zyqmail at tom.com
>
>
>
> _______________________________________________
> Skyeye-developer mailing list
> Skyeye-developer at lists.gro.clinux.org
> http://lists.gro.clinux.org/cgi-bin/mailman/listinfo/skyeye-developer
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.gro.clinux.org/pipermail/skyeye-developer/attachments/20060517/ff4024b0/attachment.htm